Installing the tub halve back together

Welcome back to frontloadbearings.com, this is video number 15.  So, on this one, I’m just gonna show you how to put these metal clips back on.  It’s actually a piece of cake, no worries.  All you need is your hammer and the clips.  You can see where they came off from because they leave these little bits of plastic hanging behind.  It doesn’t have to be perfectly in the exact same position, you just want to evenly distribute them around.  All you do is sit the clip on top, gently tap it with your hammer and that’s it.  Nothing else to it.  Very easy.  Same here, if you see another bit of plastic hanging off you’ll know one lived there.  Alright, that’s that one on.  And you’re just gonna continue, right the way around the whole machine, until you have them in place.  Now, I also just wanted to point out that there’s a guide right here.  You can see there’s a female receptacle and then the male.  When you’re putting the two halves back together, those guides line up everything nicely for you so both sides are squarely fitting together.  Second thing to know about here, is when you’re putting the top on, you can always lay a couple of 2x4 pieces of wood underneath, so when the basket goes in, the shaft on the other side isn’t hitting the floor.  Again, just go right the way around, get all of your clips back on and then on the next video, we’ll go straight to the pulley.  In fact, I think we will just go straight to the pulley right now so I’m going to hit pause.